TomTom GO GPS Navigation PDF Full Manual
Switching on and off To switch your TomTomGO on or off, press and hold the On/Off button for 2 seconds. The first time you switch on, it may take a short while for your device to start.
Setting up To set up your TomTomGO you need to answer a few questions by tapping the screen.
Battery notes We recommend that you fully charge your TomTomGO the first time that you connect it to your computer. It takes up to 2 hours to charge the battery completely. When you place your GO in the Home Dock or use the USB cable to connect to your computer, you are asked if you wish to connect to the computer. If you select No, the device will switch off if you do not tap the screen for three minutes. This happens so that the battery can recharge at a faster rate. For information on connecting to your computer, see Using TomTom HOME on page 94.
Windshield mount Use the windshield mount to install your TomTomGO inside your car. To attach the mount, press the suction cup firmly to the windshield in your car, in an area of the windshield where the glass is flat.
Make sure that both the holder and your windshield are clean and dry before you attach the mount. Place the mount so that it does not interfere with your view of the road.
Home Dock / USB cable The Home Dock or USB cable is used for charging your TomTomGO when it is not in the car and for connecting your GO to your computer.When connected to your computer, you can use TomTom HOME to manage your GO. For information about TomTom HOME, see Using TomTom HOME on page 94.
Take care of your TomTomGO Never leave your TomTomGO or accessories in view when you leave the car or they may become an easy target for thieves. You can set a password for your TomTomGO which must be entered every time you start your GO. For more information, see Using TomTom HOME on page 94.
Download TomTom GO GPS Navigation PDF Full Manual
Related E-Books:
- None Found
December 3, 2009 | Posted in Electronic Manual, Gadget Manual, GPS Navigation
Comments
Leave a Reply