Sony SXRD Rigging And Stacking Frame PDF Installation Manual

Anchoring the Projector
1. Secure the projector to the rigging and stacking frame mounting points using twelve (12) M6 x 16m Phillips Pan Head screws. NOTE: The mounting points are located at each side of the projector. There are three mounting points at each corner (total – 12). Do not tighten the screws
until ALL the mounting screws have been attached. Once attached, tighten all the mounting screws.

Stacking the SXRD CAUTION: WHEN STACKING TWO OR MORE FRAMES, A SAFETY STRAP MUST BE USED TO SECURE THE FRAMES TOGETHER. THE USE OF EYEBOLTS AND STEEL WIRE MUST ALSO BE USED TO STABILIZE THE FRAMES.TAKE EVERY SAFETY PRECAUTION WHEN STACKING MULTIPLE UNITS TOGETHER. FAILURE TO DO SO COULD RESULT IN PERSONAL INJURY, OR EVEN DEATH.

1. Remove the rubber caps from the locking feet that will be used for the upper stacker.
2. Safely raise the frame and slide the second cage underneath and line up the four (4) threaded feet to the top of the threaded feet couplers that are located on the lower unit.

3. Slowly lower the cage and thread the feet onto the feet couplers and loosely tighten the feet.
4. Once the upper cage is resting on the lower cage, insert a #2 round screwdriver into the hole (located on the side of the foot) and tighten
all four points (A). The use of the screwdriver will create the added leverage needed to tighten the adjustable feet completely.
5. Once the feet have been tightened, secure the two units together with two safety straps (commercially available). Be sure to safety strap
all four sides.

Download Sony SXRD Rigging And Stacking Frame PDF Installation Manual


Related E-Books:


December 13, 2009 | Posted in Projector Manual, Electronic Manual, Sony Manual

Comments

Leave a Reply




eXTReMe Tracker