Panasonic WV-NV Camera in the PODV7 Housing PDF Installation Manual
Install the quick release plate on top of the spacers already 1.installed in the housing. Note the orientation of the bracket. The securing tab must be facing the front of the housing. Secure the quick release plate into the housing using the (4) #8 bolts and star washers provided in the packet assembly. Attach the Camera
2.to the quick release plate. Attach safety lanyard to the back of the camera. Position the camera as shown below on the quick release plate and twist clockwise. 3. Complete wiring connections. Connect the RJ45 network cable to into the network input. Complete power connections. 4. Finish camera installation by securing the safety locking tab.
If you wish to provide a single power transformer it is recommended that:
1. Be certain that you know the total power consumption of the housing Heater (25 watts) + Blower (1 watt) + camera pan/tilt (25 watts).
2. Check the supplied wiring chart (see below) to be sure that you have the proper gauge wire for the distance that you intend to run your power wires.
3. Bring power to the 3 and 4 position of the power connector (yellow and green wire).st rd
4. Jumper from the 1 position to the 3 position and from the 2 position to the 4 position of the terminal block. Be careful not to short between the yellow and green wires.
Download Panasonic WV-NV Camera in the PODV7 Housing PDF Installation Manual
Related E-Books:
- None Found
November 20, 2009 | Posted in Digital Camera, Panasonic Manual
Comments
Leave a Reply