N64 to GC/Wii Manual Pre-assembled PCB PDF
1. Start by carefully planning how you will install the circuit inside the controller (or your enclosure). Make sure you dont cut the wires too short and that the circuit will not be in the way when you put back the cover.
2. Solder the Gamecube wires.
3. Solder the N64 wires.
4. Double check wiring and inspect for shorts. Double-checking with a multimeter is recommended if you have any doubts.
5. Test on a console. This must be done with a controller installed. Otherwise, the adapter just keeps waiting for a controller and will not be detected by the console.
6. Install hot glue over the solder points.
7. Insulate any metal part (e.g. USB cable shield) which could come in contact with the Circuit. Use electric tape or hot glue.
8. Finish the installation. (Close enclosure)
9. Play!
Download N64 to GC/Wii Manual Pre-assembled PCB PDF
Related E-Books:
- None Found
January 16, 2009 | Posted in Games
Comments
Leave a Reply