Mitsubishi XD200 Data Projector PDF User Manual

Using the remote control Battery installation
Use two AAA size batteries.
1.Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.
2.Load the batteries making sure that they are positioned correctly (+ to +, and – to -). Load the batteries from – spring side, and make sure to set them tightly.
3.Replace the back cover.

Operation area The range for operation is about 10 m (33 feet) when the remote control points to the projector. The distance to the screen back to the projector must be less than 6 m (20 feet). Depending on the type of screen, the effective distance may be different.

This projector can be connected to equipment such as PC, VCRs, video cameras and DVD players.
Important:
• Make sure that your equipment is turned off before connection.
• Plug in firmly and unplug by holding the plug, not by pulling the AC power cord.
• If connected units are set too close to one another, the image may be affected.
• Refer to the user manual of each component for details of connections.
Projector + AV equipment
Important:
• Match the color of video and audio plugs on the AV cable with the connections.
• S-video signals take priority over video signals. If you input both S-video signals and normal video signals at the same time, the normal video input automatically is inhibited.

Download Mitsubishi XD200 Data Projector PDF User Manual


Related E-Books:

    None Found

December 19, 2009 | Posted in Electronic Manual, Phone/Fax Machine

Comments

Leave a Reply