Micro Link 490-95 for LCD – Plasma TV Installation PDF Manual

Introduction The 490-95 is designed to reject interference from Plasma Displays from entering the IR signal line. These Small IR Receivers are intended to be mounted in panels, doors, cabinets, etc. for control of A/V equipment behind closed doors or any IR Repeater System that is in close proximity of a Plasma or LCD Displays. Modeled after the original 490-90, the 490-95 offers the same features as its predecessor but in a smaller mounting frame.

Micro Link 490-95 For LCD Plasma TV

Installation These units, equipped with a 7-foot cable and 3.5 mm stereo mini plug, are intended to be plugged directly into the “IR RCVR” or “AUX” jack on Xantech Connecting Blocks, such as the CB12(included), CB60, 789-44, 791-44, etc. The 490-95 should be used in installations where the connecting block is within reach of the 7-foot cable — such as when installing the 490-95 in a cabinet where the controlled equipment is behind closed doors.

Placement Placement of the IR Receiver does matter when used in the presence of a Plasma Display. Ideally it should be placed at areas around the Display with the front of the receiver flush with the front of (or set back from) the Display. If the 490-95 needs to be placed in front of the display (such as on an adjacent side wall perpendicular to the display), make sure it is placed at a location at least 45 degrees off axis from the corners of the unit – see Figure 1. The presence of Direct Sunlight and Fluorescent Lighting should not effect the reception of this unit.

Download Micro Link 490-95 for LCD – Plasma TV Installation PDF Manual


Related E-Books:

    None Found

May 10, 2009 | Posted in HDTV - LCD Plasma

Comments

Leave a Reply




eXTReMe Tracker
Furniture Outlet