Humidifier Control Pdf Pdf Safety And Installation Instruction Manual

This product must be installed by a qualified heating and air conditioning contractor. Failure to do so could result in serious injury from electrical shock.

WARNING
1.120 volts may cause serious injury from electrical shock. Disconnect electrical power to the furnace before starting installation.
2.Sharp edges may cause serious injury from cuts. Use care when cutting plenum openings and handling ductwork.

CAUTION
1.Do not set humidity higher than recommended. Condensation damage may result.
2.Do not set humidity up to recommended levels if there is condensation on the inside of windows of any unheated living space. Condensation damage may result.
3.Do not mount Humidifier Control on supply plenum or duct. The unit will not withstand supply temperatures.
4.When installing Humidifier Control on downflow furnaces, ensure blower continues to run after a heat call is satisfied to eliminate high temperatures from damaging the Humidifier Control.
5.Do not mount Humidifier Control downstream of the bypass outlet. False humidity conditions will cause humidifier to operate incorrectly.

STEP 1: Unpack the Humidifier Control Carton. Make sure all components are present (see Figure A):
A. Humidifier ControlC. Manual Mode Label
B. Outdoor Temperature SensorD. Manual Mode Resistor Case

STEP 2 :D isassemble the Humidifier Control. Remove door from the Humidifier Control by pulling the bottom of the door straight out.

STEP 3: Check the Mode Switch
With the door removed, notice the switch labeled BYPASS and POWER (partially covered by the enclosure). Make sure the switch is correctly set for the type of humidifier being installed.

STEP 4: Check the Change Water Panel indicator setting.
This setting will control when the indicator light turns on, reminding you to change your Water Panel. If your Control came with a humidifier, the Control is pre-set. If the installation site has a 3-month or shorter heating season or very hard water, you may want to adjust the setting. (see Figure B). The Control must be energized to reset the Water Panel Indicator.

STEP 5 :D etermine Location for Humidifier Control and Mount It
Humidifier Control must be mounted in the Return Duct. For proper operation, the Humidifier Control must be at least 6 inches upstream of any of the following:
• Humidifier
• Humidifier Bypass Ductwork (if applicable)
• Fresh Air Intake Ductwork (if applicable) (see Figure C) After location for Control is selected, use the perforated Humidifier Control template
(attached to these instructions) to mark the duct opening and cut it. Use 4 sheet metal screws (not provided) to mount the Humidifier Control in the duct opening and make sure Humidifier Control is sealed tightly to duct.

Download Humidifier Control Pdf Pdf Safety And Installation Instruction Manual


Related E-Books:

    None Found

December 5, 2009 | Posted in Electronic Manual, Humidifier Manual

Comments

Leave a Reply