Honeywell Temperature & Humidity Sensor with LCD PDF Manual

Thank you for selecting the Honeywell Temperature and Humidity Sensor with LCD. This device register, display and transmits temperature and humidity from the remote location to the designated main unit (receiver). In this package you will find:
• One remote sensor (transmitter) TS33C
• One User Manual
Please keep this manual handy as you use your new item. It contains practical step-by-step instructions, as well as technical specifications
and precautions you should know.

FEATURES
• Remote temperature and humidity transmission to the main unit via 433 MHz signal
• Temperature and Humidity LCD display
• Case can be wall mounted using built-in hanger
• 100 feet (30 meters) transmission range without interference
• Selection of the temperature display in Celsius or Fahrenheit
• Three available channels for temperature and humidity transmission
• Reset for all settings
• Low Battery Indication

BEFORE YOU BEGIN
• The remote sensor can be placed indoors or outdoors.
• We recommend using alkaline batteries for the remote sensor when temperatures are above 32°F (0°C). We recommend using AA lithium batteries when temperatures are below 32°F (0°C).
• Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power requirements).
• Insert batteries before first use, matching the polarity in the battery compartment.
• ALWAYS install batteries in the remote sensor before the main unit.
• Press RESET after each battery change with a paper clip or similar tool.
• During an initial setup, place the main unit as close as possible

GETTING STARTED
After batteries are installed; remote sensor will transmit temperature and humidity readings at 45 second intervals. The main unit may take up to two minutes to receive the initial readings. Upon successful reception, remote temperature and humidity will appear on the main unit’s display. The main unit will automatically update readings at 45-second intervals.
LOST COMMUNICATION
If the main unit display line for the remote sensor reading goes blank, refer to the main unit’s User Manual to find out the way to begin a new
signal search. If the signal still isn’t received, please make sure that:
• The remote sensor is in its proper location.
• The distance between main unit and remote sensor is not over 100 feet (30meters).
• The path between units is clear of obstacles. Shorten the distance if necessary.
• Fresh batteries are installed correctly in both remote sensor and main unit. If there is no reception, please perform the following steps:
• Bring the main unit and remote sensor close together.
• Remove four (4) small screws from the back of the remote sensor with small Phillips screwdriver, and open the battery compartment.
• Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor LED indicator will flash showing transmission of the signal.

TRANSMISSION COLLISION
Signals from the other household devices such as wireless doorbells, home security systems, and entry control, may interfere with this product or cause temporary reception interruption. This is normal and will not affect the general performance of the product. The transmission and reception of the temperature and humidity readings will resume once the interference subsides.
PRECAUTIONS
This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:
• Do not immerse the unit in water.
• Do not clean the unit with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits.
• Do not subject the product to excessive force, shock, dust, temperature, or humidity, which may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts.
• Do not tamper with the unit’s internal components. Doing so will invalidate the warranty and may cause damage. This unit contains no user-serviceable parts.
• Use only fresh batteries. Do not mix new and old batteries.
• Read the user’s manual thoroughly before operating the unit.

Download Honeywell Temperature & Humidity Sensor with LCD PDF Manual


Related E-Books:

    None Found

June 7, 2010 | Posted in Honeywell Manual

Comments

Leave a Reply