Honeywell HE360 Powered Flow-Through Humidifier PDF Manual Guide
Application: The HE360 Powered Flow-Through Humidifier uses the warm air furnace blower to provide humidification for the whole house. The HE360 works with virtually any Honeywell humidity control, but use with the Honeywell Perfect Climate Comfort Center™ control for optimal performance.
All wiring must comply with applicable local codes, ordinances and regulations.
1. Wire the humidifier solenoid valve, current sensing relay or sail switch, and humidistat.
See Fig. 4, 5 and 6. Refer to humidistat installation instructions for mounting and wiring information.
2. Tape the template in position and trace around the template.
3. Remove the template and carefully cut the rectangular opening.
4. Loosen the thumbscrew on the bottom of the humidifier and remove the cover.
5. Remove the humidifier pad and PerfectFlo™ water tray by grasping the tray and pulling it out of the
housing. See Fig. 3.
6. Position the humidifier housing in the hole (be sure it is level), so the locking tabs are in place on the
lower sheet metal edge of the hole.
7. Drill holes and install the two sheet metal screws at the top of the humidifier housing. Secure the
housing with the eight remaining screws.
Download Honeywell HE360 Powered Flow-Through Humidifier PDF Manual Guide
Related E-Books:
- None Found
Others Search:
Honeywell flow switch manual downloads, honeywell he360 installation, honeywell humidifier he360 manualJanuary 15, 2009 | Posted in Thermostats
Comments
One Response to “Honeywell HE360 Powered Flow-Through Humidifier PDF Manual Guide”
Leave a Reply
[...] The HP101A humidifier and temperature probes were designed to operate with the ROTRONIC indicators A2 and AM3. These [...]