Hewlett Packard Deskjet 450 Mobile Printer PDF User Guide

Using the battery (optional)
The lithium-ion rechargeable battery comes with the HP Deskjet 450CBi printer. It is also available for purchase as an optional accessory (part number C8222A, see HP Supplies and Accessories). Battery safety Use only the C8222A battery with the printer. The lithium-ion rechargeable battery is mercury-free. The battery may require recycling or proper disposal at end-of-life. When discarding a battery, contact your local waste disposal provider regarding local restrictions on the disposal or recycling of batteries. Battery may explode if incorrectly replaced or disposed of in fire. Do not short-circuit. To purchase a replacement battery, contact your local dealer or HP sales office. See HP Supplies and Accessories. To avoid risk of fire, burns, or damage to your battery, do not allow a metal object to touch the battery contacts. Do not disassemble the battery. There are no serviceable parts inside. Handle a damaged or leaking battery with extreme care. If you come in contact with the electrolyte, wash the exposed area with soap and water. If it contacts the eye, flush the eye with water for 15 minutes and seek medical attention. Do not expose the battery to storage temperatures above 122°F (50°C) or below 4°F (-20°C).

Charging and using the battery
Fully recharge the battery before using. The battery is normally warm while it is charging. Do not charge it in a briefcase or other confined space as this may cause the battery to overheat. The AC adapter is normally warm to the touch when plugged into an AC outlet.
1 Install the battery.
2 Plug in the AC adapter and turn on the printer. The Battery charge LED is green while charging, and turns off when the battery is fully charged.
After the battery is fully charged, you can use the printer without connecting to the AC power supply.

Important notes
Take note of the following when charging or using the battery: It takes approximately 1 hour and 30 minutes to charge. The Battery charge LED is green when the battery is charging. If it is red, the battery may be faulty and need to be replaced. The Power LED is green when the battery is 41-100% charged, amber when 10-40% charged, and red when less than 10% charged. Charge the battery when the Power LED turns amber. If it turns red, charge the battery as soon as possible. The battery status is also displayed on the Printer Status tab in the Toolbox. If your battery is running low, either plug in the AC adapter to charge, or replace the battery with one that is charged. A fully charged battery can last up to approximately 350 pages, depending on the complexity of print jobs. If the printer is left idle for 10 minutes, it will go into a low-power mode to
conserve battery power. Prior to long-term storage, charge the battery fully. Do not leave the battery in a discharged (empty) state for more than 6 months. To maximize battery life and capacity, observe the following temperature guidelines:
• Charging: 32° to 104°F (0° to 40°C)
• Using and storing: -4° to 122°F (-20° to 50°C).

Travel tips
The following tips will help you prepare for traveling with your printer: If you are bringing along an extra black or photo print cartridge, store it in
the travel holder (part number C8233A, see HP Supplies and Accessories) to prevent ink leakage. You can bring the printer along in a carrying case (part number C8232A, see HP Supplies and Accessories). The carrying case has compartments for both your notebook and the printer. The compartments can also be detached if you want to carry the notebook and printer separately. Turn off the printer using the Power button. This ensures that the print cartridges are returned to the home position at the right side of the printer and locked in place. Disconnect the printer cable and power adapter from the printer. Slide down the input tray extension and close the input tray. If you are traveling to another country/region, bring the necessary plug adapter with you. Use only the power adapter that is supplied with the printer. Do not use any other voltage transformer or converter. The power adapter can be used with AC power sources of 100 to 240 volts, 50 or 60 Hz. Remove the battery if you will not be using the printer for more than a month.

Download Hewlett Packard Deskjet 450 Mobile Printer PDF User Guide


Related E-Books:

    None Found

June 20, 2010 | Posted in Electronic Manual, Hewlett-Packard Manual, Printer

Comments

Leave a Reply