Honeywell RTH230B Programmable Thermostat PDF Manual
RTH230B programmable thermostat can be used to control: • a gas, fuel or electric furnace – 2 or 3 wire • central air conditioner – 2 or 3 wire • A hot water system with or without pump – 2 wires • millivolt system – 2 wires • Central heating and cooling system – 4 or 5 wire Note: These thermostats are not compatible with heat pumps or multi-stage systems.
Characteristics of the cycle RTH230B Honeywell Thermostat: • Mode selection of operating systems: heat, cold, outside fan operation • automatic selection mode or (continuous) • Programmable heating and cooling: 10, 12, 15, 20 or 30 minutes • Temperature display in ° F or ° C • replacement indicator Battery • 5-2 programming including: – energy saving preset schedule – Early Start – temporary diversion – Time display ( 12 hours or 24 hours) • Filter replacement indicator
August 29, 2009 | Posted in Honeywell Manual, Thermostats | Leave a Comment
Honeywell Electronic TL7230A Thermostat PDF User Guide
TL7230A Honeywell thermostat can be connected to an electric heater to control temperature. To remove the control module’s power base, loosen the screws below the thermostat and pull the two separate components as shown.
To install the control module on the basis of power, reversing the previous procedure. Two knobs on the back of the control module, set the limits of maximum and minimum temperature. For example, even if the control temperature setting is at 86 ° F, the temperature is kept at 77 ° F if the maximum temperature limit is 77 ° F. Use a blade screwdriver to rotate each knob up a notch points to the desired temperature limit. Each potentiometer adjustment corresponds to a temperature setting.
August 29, 2009 | Posted in Honeywell Manual, Thermostats | Leave a Comment
Honeywell Pro Non-programmable TH3110D Digital Thermostat PDF Manual
This thermostat provides electronic control of 24 Vac single stage heating and cooling systems, heating systems or 750 mV. Install the thermostat about 5 feet (1.5 m) above the ground in an area with good air circulation at average temperature. Do not install in locations where the thermostat can be affected by:
• Drafts or dead spots behind doors and corners
• hot or cold air ducts
• Sunlight or radiant heat from appliances
• Hidden pipes or chimneys
• no heating / cooling areas such as an exterior wall behind the thermostat
Make sure your package includes the following elements:
• PRO TH3110D digital thermostat (wallplate attached to back)
• Operation
• Wall anchors and mounting screws (2 each)
• AA alkaline batteries (2)
August 29, 2009 | Posted in Honeywell Manual, Thermostats | Leave a Comment