Acer LCD Monitor PDF User’s Guide

Connecting the power cord
• Check first to make sure that the power cord you use is the correct type required for your area.
• The monitor has a universal power supply that allows operation in either 100/120 V AC or 220/240 V AC voltage area. No user-adjustment is required.
• Plug one end of the power cord to the AC inlet, and plug the other end into an AC outlet.
• For units using 120 V AC: Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.
• For units using 220/240 V AC: Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. The cord set should have the appropriate safety approvals for the country in which the equipment will be installed. Power saving The monitor will be switched to “power saving” mode by the control signal from the display controller, as indicated by the amber-colored power LED

The power saving mode will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from “power saving” mode back to “on” is around 3 seconds. Display Data Channel (DDC) To make installation easier, so long as your system supports the DDC protocol, the monitor is able to plug-and-play. The DDC is a communication protocol through which the monitor automatically informs the host system about its capabilities; for example, supported resolutions and corresponding timing. The monitor supports the DDC2B standard

Installation
To install the monitor on your host system, please follow the steps below:
Steps
1 Connect the video cable
a Make sure both the monitor and computer are switched off.
b Connect the VGA video cable to the computer.
c Connect the digital cable (only for dual-input models).
(1) Make sure both the monitor and computer are switched off.
(2) Connect one end of the 24-pin DVI cable to the back of the monitor and the other end to the computer’s port.
2 Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Turn on the monitor and computer Turn on the monitor first, then the computer. This sequence is very important.
4 If the monitor does not function properly, please refer to the troubleshooting section to diagnose the problem

Front panel controls
1 Power LED: Lights up to indicate the power is turned on.
2 Power switch: Turns the power on or off.
3.4 < / > : Press < or > to navigate to the desired function, press Enter to select the function. Press < or > to change the settings of the current
function.
5 Menu/Enter: Activate the OSD menu when the OSD is off or activate/ deactivate the adjustment function when the OSD is on.
6 Auto adjust button/Exit:
a When the OSD menu is active, this button will act as the exit key (OSD menu).
b When the OSD menu is inactive, press this button for two seconds to activate the Auto Adjustment function. The Auto Adjustment
function is used to set the HPos, VPos, Clock and Focus.
7 Empowering Key/Exit:
a When the OSD menu is active, this button will act as the exit key (exit OSD menu).
b When the OSD menu is inactive, press this button to select scenario mode

Download Acer LCD Monitor PDF User’s Guide


Related E-Books:

    None Found

March 16, 2010 | Posted in Acer Manual, Electronic Manual, Monitor

Comments

Leave a Reply